What a SIP trunk is
A SIP trunk is a connection between your voice platform and a provider's network. Call setup uses SIP; the audio travels as RTP. Instead of a fixed number of copper or ISDN channels, capacity is expressed as concurrent calls and can be changed commercially rather than physically.
The trunk carries no application logic. Your PBX or platform still decides how calls are answered, queued and recorded; the trunk determines how they reach and leave the telephone network.
How it works
Your PBX sends calls to our SIP edge. We check who you are, apply your routing and pass the call to the right carrier. Incoming calls on your numbers travel the same way in reverse.
-
Your PBX or platform Asterisk, FreeSWITCH, 3CX, Teams via SBC and others
-
Internet Signalling and audio from your known addresses
-
Voicetelo SIP edge Authentication, capacity and routing
-
Carrier partners Fixed and mobile networks worldwide
Who business SIP trunking is for
Businesses on legacy lines
Organisations moving off ISDN or analogue lines that need the same numbers and dialling behaviour over IP.
Contact centres
Operations where concurrency, answer rates and outbound caller ID handling matter more than handset features.
Communications platforms
UCaaS, CCaaS and AI voice products that need voice underneath their own application layer.
Multi-site enterprises
Environments consolidating several local line contracts onto one voice interconnection.
Built for teams that make a lot of calls
Concurrency-based
Size the trunk by simultaneous calls and raise the limit from the portal when you grow.
IP or registration
Authenticate by fixed IP address or by SIP username and password.
Failover targets
Inbound calls try a second destination if the first one does not answer.
Full call records
Every attempt, answered or not, with the SIP reason when it failed.
Outbound and inbound calling
Outbound calls are matched against destination routing and your account's permissions and capacity. Inbound calls arrive on numbers assigned to your account and are delivered to the SIP endpoints you nominate, with an ordered second target if the first does not accept the call.
- Destination permissions set per account
- Concurrency limits enforced at the edge
- Delivery to one or more SIP endpoints with failover
- Call detail records for every attempt with SIP response causes
Caller ID configuration
Presented caller ID (CLI) is configured per trunk or per number. The numbers you present must be ones you are entitled to use, either allocated by us or verifiably assigned to you elsewhere. Requirements differ by destination, and some networks will not deliver calls with a CLI they cannot validate.
Concurrent calls and capacity
Capacity is sized on concurrent calls rather than minutes. Contact centres typically need headroom above their average because dialling is bursty: a queue of simultaneous outbound attempts consumes channels the moment a campaign starts.
Tell us your expected peak and busy-hour behaviour and capacity will be provisioned against it.
How many concurrent calls do you need?Codecs, media and authentication
Codec support, DTMF method and fax behaviour are confirmed during technical setup against what your platform offers, and agreed in writing before go-live rather than discovered under load. Two authentication methods are in common use: IP authentication for platforms with static public addresses, and SIP registration for endpoints without one.
Security by default
Most voice fraud losses start on the customer side of the trunk: a compromised PBX extension or an exposed SIP port can generate large charges very quickly. Controls on our side limit the damage; controls on yours prevent it.
- Destinations you never call can be switched off
- Per-account concurrency caps stop runaway traffic
- Fraud monitoring on unusual out-of-hours spikes
- Automatic blocking of repeated bad logins
- Restrict SIP at your firewall to known addresses and keep your PBX patched
Getting started
- 01Tell us what you needYour platform, the countries you call and roughly how many calls run at once.
- 02Account and verificationWe confirm your business details and agree pricing for your traffic.
- 03Connect and testCredentials or IP access are set up and test calls are placed together.
- 04Go liveTraffic moves over, with every call visible in your portal from day one.
Frequently asked questions
What is the difference between a SIP trunk and a phone line?
A traditional line is a physical circuit with a fixed number of channels. A SIP trunk carries calls over your internet connection, and its capacity is a setting expressed in concurrent calls, so it can grow without new wiring.
Which phone systems work with a Voicetelo SIP trunk?
Any standards-based SIP platform, including Asterisk, FreePBX, FreeSWITCH, 3CX and Microsoft Teams through a session border controller. Codec and authentication details are confirmed during setup.
Can I keep my existing phone numbers?
In most cases, yes. Where the country and your current provider support porting, we move the numbers and test them before the switch.
How is SIP trunking priced?
Calls are priced per destination, and capacity is set by the number of concurrent calls you need. Send us your destinations and volumes for a rate deck that matches your traffic.